Ratchet: Deadlocked: Difference between revisions

Created issue for SW mips.
m (1 revision imported)
(Created issue for SW mips.)
(4 intermediate revisions by the same user not shown)
Line 220: Line 220:
|Tester=Quattro55
|Tester=Quattro55
}}
}}
{{TestingEntry
|Status=2
|Region=NTSC-U
|OS=Manjaro
|CPU=Ryzen 7 5800X
|GPU=GTX 1070
|Revision=v1.7.5660
|Graphics=Default
|Sound=Default
|Comments=Game runs at full speed with extremely few, extremely minimal graphical issues (namely SW mips occasionally messing up spherical objects). Tested predominantly on Vulkan.
|Tester=TheTechnician27
{{TestingFooter}}
{{TestingFooter}}


Line 229: Line 240:
<!-- IssueLevel is issue severity level -1,0,1 or 2 (note, minor, serious and major accordingly)-->
<!-- IssueLevel is issue severity level -1,0,1 or 2 (note, minor, serious and major accordingly)-->
==Known Issues==
==Known Issues==
{{Issue
{{Issue
|IssueName=Framerate dips
|IssueName=Broken software mipmapping
|IsFixed=0
|IsFixed=0
|IssueLevel=-1
|IssueLevel=0
|Description=Framerate may dip when many (small) enemies or allies are in view. This occurs on original hardware. At default settings, this will always occur on the DreadZone challenge 'Endzone', where the game lags considerably as it renders many enemies on-screen.
|Description=While using the software renderer, some surfaces will be incorrectly mipmapped, such as the nodes which the bots activate.
|Workaround=First verify that your device is not the bottleneck if you experience framerate dips. If your device is too slow and you attempt the following fix, you will make the problem worse. Try to overclock the EE Cycle Rate under Settings > Emulation. 130% fixes almost all slowdowns in exchange for a higher GPU and CPU utilization. Higher values than 130% lead to certain instabilities.
|Workaround=Use hardware mode.
|FirstTestedOn=v1.7.5600
|LastTestedOn=v1.7.5600
|GithubID=5008
}}
}}


==Fixed Issues==
==Fixed Issues==
{{fixed}}
{{Issue
{{Issue
|IssueName=Broken textures
|IssueName=Broken textures
Line 252: Line 267:
|IssueLevel=0
|IssueLevel=0
|Description=Shadows in the game aren't rendered properly in software mode
|Description=Shadows in the game aren't rendered properly in software mode
|Workaround=Fixed on last Nightly version (v1.7.4726).
|Workaround=Fixed on last Nightly versions.
|LastTestedOn=v1.7.4726
}}
}}


Line 260: Line 276:
|IssueLevel=0
|IssueLevel=0
|Description=When running the game in a higher resolution than native, the bloom in the game becomes out of place.
|Description=When running the game in a higher resolution than native, the bloom in the game becomes out of place.
|Workaround= Setting that helps this issue is already added by default on newer versions of PCSX2 (tested on v1.7.4726), for older versions, like 1.6: Go to Config > Video(GS) > Plugin Settings, and enable HW Hacks and set Half pixel offset to special-texture.
|Workaround=Setting that helps this issue is already added by default on newer versions of PCSX2, for older versions, like 1.6: Go to Config > Video(GS) > Plugin Settings, and enable HW Hacks and set Half pixel offset to special-texture.
|LastTestedOn=v1.7.4726
}}
}}


Line 268: Line 285:
|IssueLevel=1
|IssueLevel=1
|Description=World geometry and some models will vanish after pausing the game or opening a vendor.
|Description=World geometry and some models will vanish after pausing the game or opening a vendor.
|Workaround=Fixed on later Nightly versions of PCSX2 (Tested on v1.7.4726), on Older versions, like 1.6: Go to Config > Video (GS) > Plugin Settings, check the "HW Hacks" checkbox, then enter "Advanced Settings and Hacks". Check the "Fast Texture Invalidation" checkbox. The issue will be fixed after rebooting the game.
|Workaround=Fixed on later Nightly versions of PCSX2, on Older versions, like 1.6: Go to Config > Video (GS) > Plugin Settings, check the "HW Hacks" checkbox, then enter "Advanced Settings and Hacks". Check the "Fast Texture Invalidation" checkbox. The issue will be fixed after rebooting the game.
|LastTestedOn=v1.7.4726
}}
}}


==Non-Issues==
{{Issue
|IssueName=Framerate dips
|IsFixed=0
|IssueLevel=-1
|Description=Framerate may dip when many (small) enemies or allies are in view. This occurs on original hardware. At default settings, this will always occur on the DreadZone challenge 'Endzone', where the game lags considerably as it renders many enemies on-screen.
|Workaround=First verify that your device is not the bottleneck if you experience framerate dips. If your device is too slow and you attempt the following fix, you will make the problem worse. Try to overclock the EE Cycle Rate under Settings > Emulation. 130% fixes almost all slowdowns in exchange for a higher GPU and CPU utilization. Higher values than 130% lead to certain instabilities.
}}


==The gallery==
==The gallery==
Line 276: Line 302:
File:Ratchet_Deadlocked_Forum_1.jpg|Ratchet: Deadlocked (SCUS 97465)
File:Ratchet_Deadlocked_Forum_1.jpg|Ratchet: Deadlocked (SCUS 97465)
</gallery>
</gallery>


{{Ratchet & Clank series}}
{{Ratchet & Clank series}}
{{ForumLinksList|list=
{{ForumLinksList|list=
*[http://forums.pcsx2.net/Thread-Ratchet-Deadlocked-SCUS-97465-U--29397 Ratchet - Deadlocked (SCUS 97465) (U)]}}
*[https://forums.pcsx2.net/Thread-Ratchet-Deadlocked-SCUS-97465-U--29397 Ratchet - Deadlocked (SCUS 97465) (U)]}}
ninja
3,000

edits